drag-racer-track-v2

Troubleshooting

I’m getting an error code!

error code	problem	resolution
100	The left time display is not found.	Check that the wiring to the left display is accurate. Failing that, check that the battery is full.
101	The right time display is not found.	Check that the wiring to the right display is accurate. Failing that, check that the battery is full.
200	The race controller is unplugged.	Plug in the race controller. Failing that, check the ethernet cable. Failing that, check that the race controller’s circuitry is accurate and not shorted.
201	The motor controller is plugged into the race controller port.	Plug the motor controller into the correct port. Failing that, check the ethernet cable.
300	The motor controller is unplugged.	Plug in the motor controller. Failing that, check the ethernet cable. Failing that, check that the motor controller’s circuitry is accurate and not shorted.
301	The race controller is plugged into the motor controller port.	Plug the race controller into the correct port. Failing that, check the ethernet cable.
302	The motor controller is plugged in, but the race controller can’t communicate with it.	Check that the motor controller is turned on. Failing that, check the ethernet cable.

The mainboard is not powering on!

• Check that the battery is full.
• Check that there is no short-circuit at the battery input.

The motor controller is beeping!

• This means that it cannot communicate with the mainboard.
• Check that the mainboard is powered on.
• If the mainboard is showing an error code, resolve the error code.

This site is open source. Improve this page.